0
2.1kviews
Thermodynamics : Question Paper Dec 2016 - Mechanical Engineering (Semester 3) | Pune University (PU)
1 Answer
0
17views

Thermodynamics - Dec 2016

Mechanical Engg (Semester 3)

TOTAL MARKS: 100
TOTAL TIME: 3 HOURS
(1) Question 1 is compulsory.
(2) Attempt any four from the remaining questions.
(3) Assume data wherever required.
(4) Figures to the right indicate full marks.


Solve any one question.Q1(a,b) Q2(a,b)

1(a) Discuss the important points of similarities and differences between heat and work.(6 marks) 1(b) A reversible heat engine operates three heat reservoirs. The engine recives 80 kW heat form reservoir A at 800 K and develops 20kW power. The engine rejects heat to sink B and sink C. The sink B and sink C are at 300 K and 400 K respectively. Determine the heat rejected to the sink.(6 marks) 2(a) Derive the following equations for an ideal gas undergoing isobaric process:
i) Work done
ii) Heat transfer
iii) Change in entropy
iv) Change in internal energy and enthalpy
v) Polytropic index of the process.
(6 marks)
2(b) A heat pump is used to maintain the house ata 23 deg.C. The house is losing heat to outside air through walls at 60,000 kJ/hr. Heat generated by various appliances inside the house is 4000 kJ/hr. For a COP 1.5, find required power input in kW supplied to the heat pump.(6 marks)


Solve any one question.Q3(a,b) Q4(a,b)

3(a) Derive the expression of efficiency for air standard Otto cycle.(6 marks) 3(b) In a standard vapor compression refrigeration cycle, operating between evaporator of -10 deg. C and condenser of 40 deg. C, the enthalpy of the refrigerant R134a at the end of the compression is 440kJ/kg. Draw the cycle on P-h chart. Assume exit of the condenser to be staturated liquid and entry of the compressor to be dry vapor. Hf (at-10 deg.C) = 186.78 kJ/kg,
hg(at-10 deg.C) =392.75 kJ/kg,
hf(at 40 deg.C) = 256.35kJ/kg,
hg(at 40 deg.C) = 419.58 kJ/kg.
Calculate:
i) Refrigerating effect
Compressor power and
iii) COP
(6 marks)
4(a) Explain with neat labeled diagram separating calorimeter.(6 marks) 4(b) An Otto Cycle engine has bore of 80 mm and stroke of 85 mm. The clearance volume of the engine is 0.06 litre. The actual thermal efficiency of the engine is 22% Determine:
i) Compression ratio
ii) Air standard efficiency
iii) Relative efficiency of the engine. Assume, gama =1.4.
(6 marks)


Solve any one question.Q5(a,b) Q6(a,b)

5(a) List down and discuss the function of at least 3 mountings and 3 accessories.(6 marks) 5(b) A gas fired boiler operates at a pressure of 100 bar. The feed water temperature is 256 deg. C. Steam is produced with a dryness fraction of 0.9 and in this condition it enters a superheater. Superheated steam leaves the superheater at a tempreature of 450. Deg. C. The boiler generates 1200 Tonne of steam per hour with a thermal efficiency of 92%. The gas used has a calorific value of 38 MJ/m3. Determine:
i) Heat transfer per second in producing wet steam in the boiler. ii) Heat transferred per second in producing superheated steam in superheater. Iii) Volume of gas used in m3/hr.
(7 marks)
6(a) Discuss the functions and location of various boiler mounting and accessories.(6 marks) 6(b) Calculate the height of the chimney, velocity of flue gases and mass of flue gases flowing through the chimney when the draught is produced equal to 1.9 cm of water. Temperature of flue gases is 290 deg. C and ambient temperature is 20 deg.C. The flue gases formed per kg of fuel burnt are 23kg. Neglect the losses and take the diameter of the chimney as 1.8 m.(7 marks)


Solve any one question.Q7(a,b) Q8(a,b)

7(a) .Define:
i) Degree of staturation
ii) Saturated air
iii) Relative humidity
iv) Dry bulb temperature
v) Wet bulb temperature
vi) Wet bulb depression.
(6 marks)
7(b) Moist air of mass flow rate 200m3/min at 15 deg. C DBT and 75% RH is heated until its tempreature reaches to 25 deg.C. Find the following:
i) RH of heated air,
ii) WBT of heated air,
iii) Heat added to air in kW.
(7 marks)
8(a) With a neat sketch represent any three of the following processes on Psychrometric chart:
i) Sensible heating and Sensible cooling
ii) Humidification and Dehumidification
iii) Cooling and Dehumidification
iv) Heating and Humidification.
(6 marks)
8(b) On a particular day, the atmospheric air conditions are recorded as 30 deg.C. DBT and 40% RH. Determine the due point tempreature and wet bulb temperature of air. If this air cooled in the air washer using recirculated spray water and having a humidifying efficiency of 90%, what is dry bulb temperature and dew point tempreature of air leaving the air washer?
!mage
(7 marks)

Please log in to add an answer.