Analog & Digital Circuits : Question Paper Dec 2013 - Information Technology (Semester 3)

1views

written 8.7 years ago by

teamques10 ★ 68k

Analog & Digital Circuits - Dec 2013

Information Technology (Semester 3)

TOTAL MARKS: 80
TOTAL TIME: 3 HOURS (1) Question 1 is compulsory.
(2) Attempt any three from the remaining questions.
(3) Assume data if required.
(4) Figures to the right indicate full marks.

Solve any four:-

1 (a) Find out relations between ?, ? and ? as current amplification factors for CE, CB, CC configurations.(5 marks) 1 (b) State ideal and practical characteristics of Op-Amp.(5 marks) 1 (c) Convert following decimal number to Binary, Octal, Herl-equivalent and gray code.
(i) (306.8)₁₀ (ii) (147.8)₁₀(5 marks) 1 (d) Add (57)₁₀ and (26)₁₀ in BCD(5 marks) 1 (e) Convert S-R flip-flop to D-flip-flop(5 marks) 1 (f) Explain parallel input, serial output shift register. (5 marks) 2 (a) Determine the following for the fixed bias.
(i) I_BO and I_CQ
(ii) V_CEQ
(iii) V_B and V_C
(iv) V_BC

(8 marks) 2 (b) For the differential amplifier as shown below calculate: -
(i) Operating points
(ii) Voltage gain
(iii) Input Impedance
(iv) Output impedance

(8 marks) 2 (c) Design a circuit to V₀=15 (V₁-V₂) where V₁ and V₂ are input voltage to Op-Amp.(4 marks) 3 (a) What are different methods used to improve CMRR in differential amplifier?(8 marks) 3 (b) Design a differentiator to differentiate an input signal that varies in frequency from 10 Hz to about 5 KHz.(8 marks) 3 (c) Explain Instrumentation amplifier using 3 Op-Amps.(4 marks) 4 (a) Design an astable multivibrator for an output frequency of 1KHz and duty cycle 40%.(6 marks) 4 (b) Minimize the following expression using K-map and realize using the gates.
Y=?m(1,2,9,10,11,15,15)(6 marks) 4 (c) Design 2-bit magnitude comparator using basic gates.(8 marks) 5 (a) Implement the following function using 8: 1 MUX
f(A, B, C, D)=?m(2,4,5,7,10,15)(6 marks) 5 (b) Implement full adder using demultiplexer.(6 marks) 5 (c) Design the divide by 7 (mod-7) asynchronous up-counter using J-K flip flop. Also state difference between synchronous and asynchronous counter.(8 marks) 6 (a) Explain universal shift register and its applications.(6 marks) 6 (b) Explain VHDL(4 marks) 6 (c) What is Zener shunt regulator? Explain and derive stability factor.(4 marks) 6 (d) Realize following using only NAND gates.
Y=(AB+BC)C.(6 marks)

ADD COMMENT EDIT